Conceptronic C150APRA2 Manual de usuario descargar pdf (Pagina 41)

CONCEPTRONIC C150APRA2 ENGLISH

The following table describes the parameters in this page.

ADVANCED WIRELESS SETTINGS

Field

Description

Transmission Rate

Select the transmission rate of the wireless network from the

drop-down list.

Multicast Rate

Select the multicast transmission rate of the wireless network

from the drop-down list. You can select Lower or Higher.

Transmit Power

Select the power for data transmission from the drop-down list.

You can select 100%, 80%, 60%, 40%, or 20%.

Beacon Period

By default, the wireless beacon frame sends the data once every

100ms. Its value range is 20—1024.

RTS Threshold

The threshold of transmission request. Its value range is 0—2347

and the default value is 2346.

Fragmentation Threshold

Its value range is 256—2346 and the default value is 2345.

DTIM Interval

Data beacon proportion (transmission quantity indication). Its

value range is 1—255 and the default value is 100.

Preamble Type

Select the preamble code from the drop-down list. You can select

long or short.

SSID

Field

Description

Enable Wireless

Select or deselect the check box to enable or disable the wireless

function.

Wireless Network Name

(SSID)

Set the wireless network name, that is, SSID. SSID is used to

distinguish different wireless networks.

Visibility Status

Select whether to hide the AP. You can select Visible or Invisible.

If you select Invisible, the AP is hidden and the terminal cannot

obtain the SSID through passive scanning.

User Isolation

Select whether users of the AP can communicate with each other.

You can select Off or On from the drop-down list. On indicates

that computers connected to the device cannot communicate

with each other.

Disable WMM Advertise

Select whether to disable WMM. You can select Off or On.

Max Clients

Set the maximum number of clients that can be connected to the

AP at the same time. Its value range is 0—32.

GUEST/VIRTUAL ACCESS POINTS-1—3

Field

Description

Enable Wireless Guest

Network

Select or deselect the check box to enable or disable the wireless

interface.

Guest SSID

Similar to the primary SSID, it identifies a wireless AP.

These settings are applicable only for more technically advanced users who have sufficient

knowledge about wireless LAN. Do not change these settings unless you know the effect of changes

on the device.

Click Apply to save the settings.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 110 111

Comentarios a estos manuales

Sin comentarios

Conceptronic C150APRA2 Manual de usuario Pagina 41

Comentarios a estos manuales

Relacionado con productos y manuales para Puntos de acceso wlan Conceptronic C150APRA2